![]() ![]() After removing it, the mouse has virtually no resistance to the surface any more! □ Also, it’s very easy to keep both the mouse and Wacom tablet clean. I tried to clean it, but found out that there is a much better solution: Just tear it off! Unlike the view at photo #3, make sure you keep the transparant plastic sticker underneath it though. Tips and tricks on cleaning your Wacom mouse Cleaning the outsideĪfter a while, the cloth sticker on the bottom of the mouse collects so much dust, grease and dirt that it makes it harder to move your mouse than is comfortable. Put back the top half, screws and sticker corners – Fixed!.Repeat untill the desired ‘smoothness’ is reached. If it does, put in the screwdriver again and gently push a little in the directing of the dent. Pull out the screwdriver and try the scroll wheel to feel if it needs more adjusting. Just put a flat screwdriver between the ‘red’ disc and the ‘green’ axis and the pressure will flatten the dent some.Of course, the metal disc is only very thin and quite easy to deform. The little dent in the litte metal disc (red) makes it hard for the axis (green) to rotate. The right end of the scroll wheel axis is attached to a little mechanism that gives the wheel resistance when you try to scoll.You’d have to make a new one by hand and it’s not always easy to get fit if you can pull it of at all! In this case it didn’t help much though, so I had to go further: Always be very carefull, not to break it or overbend it. That way, it will get more resistance and it will be harder to click the switch. Sometimes you can bend it away from the switch, just a bit. Then the strip presses the actual switch. To the left of the scroll wheel, there is a little metal strip where the axis of the scroll wheel presses on when you press the wheel.If you, like me, prefer a light mouse above fooling yourself something is better when it’s heavy, unscrew it and leave it out.It’s only there to give some weight to it, so it feels more solid! It isn’t connected to the circuit board, and no, it’s not magnetic either. Now we can easily lift of the upper half of the casing.In this case there are three screws, the last one is in the center, beneath the sticker.Use your nail or a flat screwdriver to get under it, then just pull. Since the complete bottom of this mouse is stickered, we can just peel of a corner to reach the first screw. Later models, like the Wacom Intuos3 are very alike. This Wacom Intuos2 mouse for example has three. Usually there are one to four screws, hidden under a sticker. This one comes with the Wacom Intuos 2 set, but this how-to will work with the majority of scroll wheel mouses. You can hack your Wacom mouse too and fix all kinds of mouse trouble: What you need to make it rotate more smoothly This annoyed me so much that I decided to try to adjust it. Every time you use it, you press the scroll wheel button, whether you like it or not. So you bought a Wacom Intuos tablet and hey, the wireless mouse that comes with it is quite alright! It even has a scroll wheel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |